Internal Vents Buy on Amazon

Door vent for interior doors

A two-sided louvered grille that keeps air moving between rooms when the door is shut. It fits a 17 × 3⅛ in cut-out in doors 1 to 1¾ in thick, and the template and screws are in the box.

  • Five colors
  • ABS plastic, rust-free
  • Made in the EU
White Internal Vents door vent fitted near the bottom of a closed interior door, with air passing through the louvers

Will it fit your door?

Measure the hole in the door, not the old vent. If the hole is 17 × 3⅛ in, or you're cutting a new one, this vent fits.

The frame is bigger than the hole so it hides the cut edges on both faces. The two halves slide into each other through the door, which is why the louvers line up on both sides and why it works on doors from 1 to 1¾ in thick.

How door vent sizes are measured

Door vent dimensions Outer frame 17.7 by 3.6 inches (450 by 92 mm). Cut-out in the door 17 by 3 1/8 inches (432 by 80 mm). Fits doors 1 to 1 3/4 inches (26 to 44 mm) thick. Frame 17.7 in 450 mm Cut-out 17 in 432 mm 3.6 in92 mm 3⅛ in80 mm cut-out Door 1–1¾ in 26–44 mm Section through door

Pick a color to match the door

Most buyers choose white for painted doors. Beige, gray, brown and black blend with wood and darker finishes.

Buy white on Amazon

Showing: White

White two-sided louvered door vent, 17.7 × 3.6 in, front view
White door vent fitted near the bottom of a matching interior door
White
Beige door vent fitted near the bottom of a matching interior door
Beige
Gray door vent fitted near the bottom of a matching interior door
Gray
Brown door vent fitted near the bottom of a matching interior door
Brown
Black door vent fitted near the bottom of a matching interior door
Black

Where a door vent helps

Any room that's kept closed but still needs air from the rest of the house.

  • BathroomsAn exhaust fan can only pull air out if air can get in. With the door shut and no gap underneath, steam lingers. Bathroom door vents
  • Laundry roomsLets damp, warm air escape after a wash so the room dries out between loads.
  • Closets and pantriesKeeps a closed cupboard from smelling stale. Closets, laundry, pantries
  • Bedrooms with a supply registerGives the air an easy path back to the return, and stops doors from slamming when the system runs.

Installs in an afternoon

You'll need a drill with a 3/8 in bit, a jigsaw and a screwdriver.

  1. Mark the cut-out

    Take the door off its hinges and lay it flat. Tape the template where the vent will go, usually low on the door, and trace it.

  2. Drill the corners

    Drill a hole inside each corner of the outline with a 3/8 in bit. Painter's tape over the lines helps stop the face from chipping.

  3. Cut the opening

    Join the holes with a jigsaw and a fine-tooth blade. Keep to the line: the opening should be 17 × 3⅛ in.

  4. Fit both halves

    Push one half in from each side. The sleeves slide into each other so the louvers line up on both faces.

  5. Screw together

    Pick the screw length that matches your door thickness (25, 35 or 45 mm) and tighten until the frames sit flat.

Full installation guide with tips

Common questions

All questions and answers

What size hole does this door vent need?

A rectangular cut-out of 17 × 3⅛ in (432 × 80 mm). The frame itself is larger, 17.7 × 3.6 in (450 × 92 mm), so it covers the cut edges on both sides of the door.

I'm replacing an old vent. How do I know it will fit?

Take the old vent out and measure the hole in the door, not the old vent. If the hole is close to 17 × 3⅛ in, this vent fits. The frame overlaps the cut-out by about 6 mm top and bottom and 9 mm at each end, so a hole slightly larger is still covered. A smaller hole can be enlarged with a jigsaw using the template.

How thick can the door be?

Doors from 1 to 1¾ in (26–44 mm) thick. Most interior doors in North America are 1⅜ in, which is well inside that range. Three screw lengths are included for different thicknesses.

Does it look the same on both sides?

Yes. It comes as two halves, one for each face of the door. They slide into each other through the opening, so you see a finished louvered frame on both sides.

Fitting out a building?

Contractors, builders, property managers and hotels can order in larger quantities, in any of the five colors, shipped directly from the EU.

Or write to [email protected]